Prusa BGCode Viewer Won't Open and Prusa Slicer won't install

Dernier message

RSS

eager

(@eager)

Estimable Member

Prusa BGCode Viewer Won't Open and Prusa Slicer won't install

I tried posting that the Prusa BG Code viewer that was installed months ago on my W11 laptop won't open and now the Prusa Slicer 9.4 and 9.3 won't proceed with the Configuration Wizard to install. Is Slicer 9.2 the last stable version? If so, pls share the link to that version?

Whne I ted to post ealer I got this message from this list.

We’re sorry

This page was broken into 500 pieces. We are doing our best to put everything back in its place as quickly as possible.

Thank you.

Publié : 16/03/2026 10:35 pm

Statistiques du forum

598 Forums

70.9 K Sujets

497.1 K Messages

17 En-ligne

82.3 K Membres

Le dernier des messages: Automatic filament switch for large prints? Notre nouveau membre: jbpr Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé