Notifications
Clear all
MK4 version 5.0 filament change
Hi,
I used Prusa i3, MK3 now MK4 kit firmware version 5.0
So far happy with print quality and overall prints. Only problem I have is with filament change. When replacing the filament during the print, the print stops, then the old filament is pushed out OK. Then the notification on screen to pull out the filament, done but then it takes 7 minutes to ask for new filament.
So far every time I do this operation it takes too long. Is everyone hsa this issue or is it jsut my problem?
Thanks
Napsal : 15/10/2023 8:44 am