Avisos
Vaciar todo

Mk4 under-extruding?  

  RSS
Obadiah
(@obadiah)
Miembro
Mk4 under-extruding?

This was happening with PETG so I tried a hard reset full re-calibration and it is still under-extruding. I changed the filament to Prusa PLA and this is the latest print. Still under-extruding or at least that's what I think it is. Adjusting the 2 spring loaded screws on the idler makes no difference. Slowing it down makes no difference.

I have previously printed this item perfectly. 

Respondido : 24/03/2024 10:50 pm
Compartir: