Notifiche
Cancella tutti
Hueforge prints with Input Shaper
Hello,
Hueforge prints usually have 0.10 at the base and 0.08 in the rest of the figure, the IS profiles for a 0.4 nozzle, the minimum is 0.10.
Could it be a problem to set 0.08 using IS?
Thank you.
Postato : 23/12/2023 9:34 am
RE: Hueforge prints with Input Shaper
I am just now playing around with this on my 5 head XL. What did you end up doing?
Postato : 19/02/2024 12:37 pm