Notifications
Clear all
First Layer Randomly Printing Above Print Bed on MK4 - Small Cubes Test
Hello everyone,
I'm experiencing a perplexing issue with my Prusa MK4 while printing small cubes. During the first layer, some of the cubes tend to randomly print above the print bed rather than adhering to it. This doesn't happen consistently with all cubes, but it occurs often enough to disrupt my prints.
I've attached photos to illustrate what's happening. Has anyone else experienced similar problems or have any suggestions on how to resolve this?
Thank you in advance for your help!
Napsal : 10/10/2024 10:29 am