Notifications
Clear all
Firmware Feature Request - Add in Tuning Page Change Filament "Are you sure? Yes/No"
It's happened twice now where I'd go into the tuning page to adjust my nozzle or heat-bed temp, only to scroll up to go back to the main running screen and accidentally click on the change filament selection. I wish there was a yes/no prompt if you click on change filament during a print so you don't risk messing up your print.
Publié : 08/04/2024 3:15 am
RE: Firmware Feature Request - Add in Tuning Page Change Filament "Are you sure? Yes/No"
Suggestions like this are best made on the Prusa Mk4 Git hub page
where the developers spend most of their time
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Publié : 08/04/2024 8:58 am