Notifications
Clear all

Constant clogged nozzel  

  RSS
jfulton3
(@jfulton3)
Membre
Constant clogged nozzel

Recently I have been getting constant clogged nozzle about an hour into a print.  I have tried loosening and tightening the idler.  The filament is new Prusemaent PETG. There has been no hardware changes so I have no idea what could be causing the problem,  U have upgraded, downgraded then upgraded the firmware with the clogges happening in 6.02 6.03 and 6.04 version of the firmware.

Publié : 20/07/2024 11:43 am
Partager :