Brief Video of the MK4 with Firmware 5.00 A2 and Prusa Slicer 2.6.0 printing with input shaping enabled
This is a link to a video of the MK4 with Alpha 2 of the 5.00 firmware and Prusa Slicer 2.6.0 set for 0.2mm Input Shaper.
https://drive.google.com/file/d/1G3PGOgU7mUEHuHXnQZ0DtrMBXkeymx02/view?usp=sharing
Input shaping took an 11 hour print down to 5.5 hours.
I will post pics of 4.7.0 without input shaping and 5.0.0 with input shanping when the print is finished.
RE: Brief Video of the MK4 with Firmware 5.00 A2 and Prusa Slicer 2.6.0 printing with input shaping enabled
Thanks for sharing!
Nice fan cover, does it add a little too mich weight that might effect IS?
RE: Brief Video of the MK4 with Firmware 5.00 A2 and Prusa Slicer 2.6.0 printing with input shaping enabled
I'm not sure if the additional mass of the fan cover will affect input shaping or not.
I can try it with and without.
RE: Brief Video of the MK4 with Firmware 5.00 A2 and Prusa Slicer 2.6.0 printing with input shaping enabled
As long as there's no noticeable drop in print quality at the end, Input Shaper on the MK4 is looking impressive - especially at half the print time!!!
--> MK4 - MK4S - MINI+ - Accelerometer Guide <--
RE: Brief Video of the MK4 with Firmware 5.00 A2 and Prusa Slicer 2.6.0 printing with input shaping enabled
As long as there's no noticeable drop in print quality at the end, Input Shaper on the MK4 is looking impressive - especially at half the print time!!!
Only thing would be layer adhesion of PETG printed at higher speeds.
i already printed PETG with my Mosquito Hotend at 100mm/s, but the parts became brittle
RE: Brief Video of the MK4 with Firmware 5.00 A2 and Prusa Slicer 2.6.0 printing with input shaping enabled
As long as there's no noticeable drop in print quality at the end, Input Shaper on the MK4 is looking impressive - especially at half the print time!!!
Only thing would be layer adhesion of PETG printed at higher speeds.
i already printed PETG with my Mosquito Hotend at 100mm/s, but the parts became brittle
I have experienced that as well. I had to reprint at 0.20mm speed after I had some layer adhesion problems with the Input Shaper.
Maybe they need to adjust the speed, heat, feed rate or fans to account for that.
But it was impressively fast.