Notifiche
Cancella tutti

6.0.0-RC1+ Cold Pull wizard script  

  RSS
Sembazuru
(@sembazuru)
Prominent Member
6.0.0-RC1+ Cold Pull wizard script

I'm unwilling to install RC firmware onto my MK4, but I'm curious about the new cold pull wizard. For those of you who have installed the RCs and used the cold pull wizard, would you please describe the script of what happens? (i.e. what the printer does, what notifications you get on the screen, etc.) I want to see how close the baked in procedure is to my personal cold pull process so I can potentially make suggestions before the RC period ends. I haven't seen anyone on these forums talking about it yet, and I'm unable to find the code in the Buddy github page (probably not searching for the right thing).

See my (limited) designs on:
Printables - https://www.printables.com/@Sembazuru
Thingiverse - https://www.thingiverse.com/Sembazuru/designs

Postato : 15/04/2024 4:35 pm
Sembazuru
(@sembazuru)
Prominent Member
Topic starter answered:
RE: 6.0.0-RC1+ Cold Pull wizard script

Well, nevermind. 6.0.0 release has dropped. Time for me to find out myself.

See my (limited) designs on:
Printables - https://www.printables.com/@Sembazuru
Thingiverse - https://www.thingiverse.com/Sembazuru/designs

Postato : 16/04/2024 8:32 pm
Condividi: