Notifiche
Cancella tutti
Why all of the stringies?
Printed on MK4 with Firmware 4.7.1, sliced with Prusa Slicer v2.6.0.
Generic PLA wood like, organic supports enabled, 0.20mm Speed
File from printables.com.
Why do I have all of these stringies. What can do to avoid them in the future
Questa discussione è stata modificata 1 year fa da ChiTownGuy
Postato : 14/07/2023 6:04 pm
RE: Why all of the stringies?
that model doesn't require supports. try without supports and lower your temp. If problem persist change nozzle. try again. also check e retraction settings may need adjusting for that filament.
Postato : 15/07/2023 2:20 am
Look up threads here about drying filamemt.
Cheerio,
Postato : 15/07/2023 2:26 am
carlmmii e Peter wainwright hanno apprezzato