Insane Stringing has became the bane of anything I print
Atm the quickest way I have found to remove the insane amount of stringing is using a candle and run a naked flame over the print when its done to clear out the mass of strings..Then its wire brush time to give it a good ole scrub a dub to clean off blobs and the hairs that the flame missed.Im pretty sure this is not working as intended....i have tryed lowered the extrusion speed, slowing the print down, speeding it up, and my favorite yell and scream at it and tell it that it's not a 1970 's skin magazine.
As for printing, its a beast ...unfortunately when its finished printing it still is a beast (hair everywhere) .Anyone had any luck in the war of the hair ?
now and again i can tolerate but every single print ? I paid good money for this rolls Royce of a printer
RE: Insane Stringing has became the bane of anything I print
have you tried lowering the print temperature?
Have you spoken to Prusa Chat?
some folk have had faulty thermistors...
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK