Notifications
Clear all
Filament Not Advancing
Just finished building my printer yesterday and all tests passed. I can load filament and the extruder advances fine but once I start printing, the filament never advances. I played around with tightening the springs but so far am having no luck. The print lays down the first few layers but the filament runs out and no more will advance. Any ideas?
Publié : 06/01/2025 2:47 pm
Topic starter
answered:
RE: Filament Not Advancing
Fixed my issue. I had stupidly installed the tension clip inside down so the filament had virtually no pressure on it.
Publié : 06/01/2025 9:05 pm