Notifications
Clear all

Problem with support attached to model  

  RSS
Rick
 Rick
(@rick-4)
Member
Problem with support attached to model
Posted : 19/09/2025 1:26 pm
Tim
 Tim
(@tim-24)
Member
RE: Problem with support attached to model

You have a problem with the filament and extrusion, not the supports. The term 'stringing' also applies. You may want to do a temp tower test and maybe even dry the filament. 

Posted : 19/09/2025 10:40 pm
Rick
 Rick
(@rick-4)
Member
Topic starter answered:
RE: Problem with support attached to model

Thanks Tim!

This filament was new, so drying will not a solution.

i searched for stringing and oozing and how to setup the retraction. I tried some options, but I didn’t noticed any difference 

Posted : 20/09/2025 6:08 am
Share: