Notifications
Clear all
Upgrade from MK3s to MK3.5s make inaccurate prints
After Upgrade printer is a lot faster, but prints not accurate anymore.
On the old MK3 adjusting x,y and z Axis is possible.
With the buddy-board and current Firmware from the MK3.5, MK4, store korrekt values is not possible.
Today, each of my printers produces prints of different sizes under the same conditions.
What was the reason why Mr. Prusa disabled the STANDARD COMMAND M500?
Until now, the only reason to buy a prusa printer that was outdated in concept
was the open system architecture. Is that history now?
best regards
joerg
Napsal : 14/12/2024 3:18 am