Notifications
Clear all
Probe is no longer surveying the bed levels
I just upgraded MK4 to MK4S, and reloaded the firmware, and am now getting a poor base layer in some sections of the bed. I now see that the bed leveling matrix "survey" is no longer being conducted, and am suspicious that that may the the root cause. I'm wondering if anyone else has experienced this. Is there a on/off switch somewhere that I missed?
I initially used 6.1.3 firmware, but the chat person suggested 6.2 alpha, but the same problem persists.
Also, the message for remaining time and time of completion is only showing N/A. Any thoughts on restoring that feature would be appreciated.
Publié : 25/10/2024 9:50 pm