Notifiche
Cancella tutti
Linearity Correction for MK3.5?
I might have missed it somehow, but I cannot find settings for linearity correction on the MK3.5. I used this for my extruder motor on my MK3s+ before and would like to carry over the same improvement to print quality on my MK3.5.
I imagine that it wasn't added to the MK3.5 firmware because it's a port of the MK4 firmware and unnecessary on that machine because of the planetary drive and 0.9 deg stepper motor. If that's the case I'd love to see it added in a future firmware revision.
Postato : 18/10/2024 12:30 am