Avisos
Vaciar todo
Chaning filament during printing
I recently upgraded my Prusa Mk3s+ to 3.5s. Everything works fine till one time I need to change filament during printing. Old filament was unloaded smoothly but when I was trying to insert new filament, since the motor is still powered but not turning, I cannot insert the filament between the gears. I remember when I was printing with Mk3, that's not problem, I could always insert new filament quite easily between the gears. Prusa gurus, any tip or insight? Thank you
Respondido : 29/08/2025 1:57 am