Notifications
Clear all
Printable parts for the enclosure when doing the MK3S+ upgrade to MK3.5S
I was under the impression there were additional printable parts for the enclosure when doing the MK3S+ upgrade to MK3.5S. But I am unable to find them when trying to download the printable parts files. Even the assmbly instructions seem to indicate these files are available. Se the "Blue" highlighted poortions in the attached screen snip.
Posted : 29/04/2025 1:48 pm
RE: Printable parts for the enclosure when doing the MK3S+ upgrade to MK3.5S
Yes, you're looking for the right place! Prusa Research provides all official printable parts for the **MK3S+ to MK3.5S upgrade** on **Printables.com**. You'll find them under the **MK3.5(S) printable parts model**, where you can download the necessary STL files or G-codes for your specific setup.
dog sounds
Posted : 16/06/2025 10:39 am