Notifications
Clear all
Under extrusion outer wall
hi guys thanks for looking at my question. Just got a quick one here
I’m very happy with my MK3 printers (I have 4 of them). They are workhorses going over six years now with proper maintenance.
On one of my units on occasion with the same model that I’ve been printing for years I had this imperfection on the Outer wall.
You can see it’s in the middle and then it continues as normal.
What would cause something like this? Is it something to do with maybe a snag in the filament it - as if it was wound too tight or is it an indication of something else?
Everything on this MK3 has been replaced and has been operating perfectly for the most part / but I did notice This issue and I want to be able to troubleshoot it.
Thank you for your time.
Posted : 11/08/2025 12:08 pm