Notifications
Clear all
After upgrade, extruder motor noisy, not working properly
Can this have been caused by the new board or has my extruder stepper motor coincidentally just failed, or is something else going on here? Any suggestions as to what I should try? I opened the door to show it but it makes the same noise with the idler in any position.
Opublikowany : 15/02/2026 3:10 pm
Topic starter
answered:
RE: After upgrade, extruder motor noisy, not working properly
Never mind. It was the extruder motor. I bought a new one and replaced it, and boy, was that a headache. But it works fine now.
Opublikowany : 24/02/2026 12:23 am
RE: After upgrade, extruder motor noisy, not working properly
Hey can hear or see attachment anymore, but did the noise sound like a vibration. I think my motor has died too.
Opublikowany : 26/04/2026 10:22 pm