XYZ Calibration failed. Bed calibration point was not found
 
Avisos
Vaciar todo

XYZ Calibration failed. Bed calibration point was not found  

  RSS
Shrike Sports
(@shrike-sports)
New Member
XYZ Calibration failed. Bed calibration point was not found

Hi Guys

This fails on the 1st of 4. I have carried out all the remedies I can see on posts etc. been at it for a few days now with no luck. 

Anyone with definitive answers or anyone in Brisbane that can help.

Cheers

 

Respondido : 16/04/2020 1:41 am
Mirek
(@mirek-2)
New Member
RE: XYZ Calibration failed. Bed calibration point was not found

Hi Michael,

I am the new here too and had the same problem.... 🙁

BUT it is solved….(right now)  the trouble was in wrongly installed hotend. Hotend was installed too low in extruder.

Respondido : 16/04/2020 11:16 am
pcweber
(@pcweber)
Miembro
RE: XYZ Calibration failed. Bed calibration point was not found

Verify your PINDA height following the installation instructions, I would suspect that it may be too high to get the 1st calibration point.

Good luck, be safe.

Phil

Stay safe and healthy, Phil

Respondido : 16/04/2020 8:27 pm
Shrike Sports
(@shrike-sports)
New Member
Topic starter answered:
RE: XYZ Calibration failed. Bed calibration point was not found

I found the problem. It worked when I did it without the paper.

Respondido : 16/04/2020 10:49 pm
Mark
 Mark
(@mark-13)
Eminent Member
RE: XYZ Calibration failed. Bed calibration point was not found

Don't forget to keep the bearing rods oiled. To much drag on the bearings causes big problems with calibration.

Respondido : 19/04/2020 10:05 am
Compartir: