Notifications
Clear all

Why 100 layers for flow calibration?  

  RSS
tschaboo
(@tschaboo)
Active Member
Why 100 layers for flow calibration?

I was surprised when I read this knowledge base article:

https://help.prusa3d.com/article/extrusion-multiplier-calibration_2257

Regarding the visual method.... 

Why print 91 sparse infill layers before starting the 5 top solid infills? Shouldn't 1, 2 or maybe 3 be plenty? 

If I would have read that somewhere else I'd assume "no one took the time yet to describe a more sophisticated/efficient method". But my experience with Prusa's documentation is that it's usually very refined, accurate, efficient. So I'm ready to be surprised again. 😀 

Publié : 10/09/2024 11:03 am
Partager :