Which Hotend and Extruder should I choose?
 
Notifiche
Cancella tutti

Which Hotend and Extruder should I choose? Poll is created on Jun 19, 2022

  
  
  
  

[Risolto] Which Hotend and Extruder should I choose?  

  RSS
arthurdanielkalk
(@arthurdanielkalk)
New Member
Which Hotend and Extruder should I choose?

Hello everyone, For my Rat Rig v-core 3 printer I have a question for you. Orbiter 2.0 or LGX® Large Gears eXtruder as extruder in your opinion Is it better to buy Rapido UHF or mosquito magnum? Which ones do you think I should choose? what are your suggestions

Postato : 19/06/2022 6:58 pm
Gordon W
(@gordon-w)
Reputable Member
RE: Which Hotend and Extruder should I choose?

As this is a forum for Prusa Printers, you may find you get a better response in a forum for Rat Rig printers, or at least a general forum, rather than one focused on Prusa.

Regards,

 

Gordon

Postato : 19/06/2022 8:05 pm
arthurdanielkalk hanno apprezzato
Condividi: