Notifications
Clear all
Which Hotend and Extruder should I choose?
Hello everyone, For my Rat Rig v-core 3 printer I have a question for you. Orbiter 2.0 or LGX® Large Gears eXtruder as extruder in your opinion Is it better to buy Rapido UHF or mosquito magnum? Which ones do you think I should choose? what are your suggestions
Posted : 19/06/2022 6:58 pm
RE: Which Hotend and Extruder should I choose?
As this is a forum for Prusa Printers, you may find you get a better response in a forum for Rat Rig printers, or at least a general forum, rather than one focused on Prusa.
Regards,
Gordon
Posted : 19/06/2022 8:05 pm
arthurdanielkalk liked