Where are the Trilab Delta printer community/forums?
Hello,
I am thinking of purchasing a Trilab DeltiQ 2, and was hoping to find some discussions/community from real users.
But there seems to be not much discussion in these forums, and Trilab's website ( https://trilab3d.com) seems not to have a community forum either.
Does anyone know where users are chatting about Trilab's printers?
Thanks,
Mike
RE: Where are the Trilab Delta printer community/forums?
I'm wondering the same thing. I just installed a DeltiQ 2 Plus yesterday, and have already fallen in love with it.
I'm finishing up a second print now, and it's easier to use/ setup than the Prusa Mini so far. It's faster for sure, but not sure how fast yet.... haven't done a back-to-back comparison.
RE: Where are the Trilab Delta printer community/forums?
Hello,
I will receive mine tomorrow and a section dedicated to this printer would be welcome to share our experiences.
RE:
Hi there,
I've had my DeltiQ2 plus for 3 months and love this printer, it's quiet, reliable and it allows you to make very tall models, I don't regret my purchase
RE: Where are the Trilab Delta printer community/forums?
anyone know how to connect using the web interface? having troubles. Using the supplied "usb to ethernet" adapter. Either plugged into wall port or my laptop? Nothing per 10.0.0.5 address nor IP address shows up on DisplayController.
RE: Where are the Trilab Delta printer community/forums?
I would love to know the same thing. I was wondering if they were going to offer an MMU for it.
RE: Where are the Trilab Delta printer community/forums?
Even though this thread is a bit older, I just bought a used TRILAB AzteQ Industrial. I would also love to see a Trilab section here in the forum.