Clear all

Wanhao i3 COnversion to Prusa  

New Member
Wanhao i3 COnversion to Prusa

Hey Everyoune!

Hope y'all are doing well and safe in the COVID 19 crises of things.

I relatively new to 3D printing and had purchased a Wanaho Duplicator i3, that worked well for a while, until it drove me nuts (currently the extruder stepper just keeps clicking, and I cannot understand why that is, I'm guessing the Melzi board failed on me, everything else works - help!).

So went and bought an MK3S and was mind blown. I really wanted to sort of "convert " my Wanaho into a Prusa (add a Prusa controller, power, auto calibration, better cable management and arrangement, etc whilst being able to use the hardware I already have - the metal frame, steppers, MK10 extruder and nozzles, power supply unit). I was wondering if anyone could guide me on this, if someone had any prior such experiences perhaps?

Posted : 01/06/2020 2:22 pm
New Member
RE: Wanhao i3 COnversion to Prusa


Maybe this is something for you:

Posted : 01/06/2020 8:34 pm