Tuning the PC Blend Carbon Fiber profile
I was getting some serious over extrusions from the PC CF using the Prusa Slicer default "Prusament PC Blend Carbon Fiber" profile, so I ran a series of vase-mode cubes to tweak the extrusion multiplier. After several iterations, I ended up at *0.7* for an extrusion multiplier.
I think I went too far. Because of the textured surface of the CF, I think I need to factor in some kind of "surface coefficient."
I was wondering if anyone else has made adjustments to the profile.
Best Answer by Swiss_Cheese:
I'd love to help you out, but apparently you bought to only roll that was available, for the month. I heard a rumor that that Prusa was going to make another roll available in October, so maybe whoever gets that roll will be able to help you out.
Good Luck
Swiss_Cheese
I'd love to help you out, but apparently you bought to only roll that was available, for the month. I heard a rumor that that Prusa was going to make another roll available in October, so maybe whoever gets that roll will be able to help you out.
Good Luck
Swiss_Cheese
The Filament Whisperer
LOL
😆