Notifications
Clear all
Try to add printer. Error and then crash.
I have been using the latest Prusa slicer since last year. I noticed that i have been getting an error message on start up going back to at least 2.5 and continues with 2.6 even though 2.6 was a completely new install.
I ignored this since it wasn't causing any problems with the slicer or the printing. But I looked and realized that neither of these paths exist on my computer.
I tried to add a new printer, but due to, it appears, that the path the slicer is looking for does not exist, it displays this message -
Followed by this message -
And then it simply crashes.
Any suggestions?
Opublikowany : 02/08/2023 5:41 pm