Notifications
Clear all
Tree support broke mid-print
Hello. I was printing Bellatrix's wand with tree supports for about 3 hours.The support broke mid-print.
What could be the reason for this?
I am using Prusa slicer, 0.2mm layer height, PLA+,200°,60°. Ender 3 S1 pro
I was printing a similar wand a couple of days ago and I did not have any issues. I have not changed anything on the settings besides the flow rate.
Here is the video.
https://www.tiktok.com/@craftsman_chris/video/7341005200100019489?_r=1&_t=8kHtazuH1of
I am not sure if this is the correct topic for this question.
Posted : 29/02/2024 4:30 pm