Notifications
Clear all
Still Issues With Print
I have printed this a few times with different settings to see if it makes any difference. As you can see the top left seems to keep doing this on prints but I don’t know why. I have changed the layer height and slowed the print down but it keeps doing it. Please can anyone help or give suggestions. I have done this in both prusaslicer and cura but it always does this. Thank you
Opublikowany : 19/03/2023 7:46 pm
Is it warping and lifting off the bed in that corner?
Cheerio,
Opublikowany : 20/03/2023 2:57 am