Notifications
Clear all

start and end gcode  

  RSS
jlbrugger
(@jlbrugger)
Member
start and end gcode

Hello, I have an MK3S + which works perfectly fine, but I also have an X2 sidewinder artillery and am desperately looking for the start and end gcode for prusaslicer.

If anyone could help me out that would be really cool. I don't really like cura.

In addition I am trying with my MK3 the beta 3 of prusaslicer 2.3.4 which looks really good. Thank you in advance for your help.

Posted : 12/12/2021 4:45 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: start and end gcode

Have you tried the Sidewinder X1 profile, or the Sidewinder BL TouchProfile? 

they might be a good starting point

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Posted : 12/12/2021 6:19 pm
jlbrugger
(@jlbrugger)
Member
Topic starter answered:
RE: start and end gcode

Yes, but I have too much problems with my sidewinder x1 profile and I amm looking for a good profile...

Jean-Luc

Posted : 12/12/2021 7:18 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: start and end gcode

Hopefully someone can help you Jean Luc

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Posted : 12/12/2021 9:24 pm
Share: