Slicing with Slic3r PE on non-prusa machine causes thermal runaway
 
Notifications
Clear all

Slicing with Slic3r PE on non-prusa machine causes thermal runaway  

  RSS
Jacko
(@jacko)
New Member
Slicing with Slic3r PE on non-prusa machine causes thermal runaway

Hi all, I have a Prusa MK3 and a ReDuplicator running RAMPS 1.4/ Marlin 1.1.9. I have started to hate Cura lately and wish to use Slic3r PE as my main slicer. Since the MK3 and ReDuplicator are pretty similar, I made a copy of the MK3 profile and edited the autoleveling GCode to be G29 for the BLTOUCH.

Unfortunately, when I use GCode generated by Slic3r on the ReDuplicator, I get a thermal runaway error after the first few layers. Does any one have any idea of what this is caused by? The ReDuplicator works does *not* have any wiring issues and the thermistors are working properly since I can run Cura GCode with zero issues.

Opublikowany : 10/02/2019 3:16 pm
Share: