Received and old Prusa. Can't find model
As mentioned, I got a free Prusa Printer. It looks to be an I3, but that's as far as I can get. If it helps, it has a clear Plexiglas body.
The board shorted out, when a plastic piece holding the Z axis sensor broke, and made metal contact. I ordered a new one. I tried following the wiring as it came off of the other board. The board lit up, but all I got "white" lines across. I tried plugging it into my laptop that has prusa slicer. I reran the configuration setup, but Nothing happened. ...that's as far as I've gotten.
I've tried to look up the wiring schematics, but it's showing a board with 3 fuses, and I have an Arduino Mega 2560 R3, SO I'm airring on the side of caution on what to do next.
Disclaimer ... I'm a total NOOB to this, and this is my 1st time, so be gentle.
RE: Received and old Prusa. Can't find model
RE: Received and old Prusa. Can't find model
RE: Received and old Prusa. Can't find model
That's probably a Prusa reprap clone.
A search returns the following printer.
Folger Tech RepRap Prusa i3
For more information,
https://www.3dprintersbay.com/folger-tech-reprap-prusa-i3-clear-frame-full-3d-printer-kit
RE: Received and old Prusa. Can't find model
Now that I see the pictures it's probably a clone of a clone.
This one is more like it I think.
https://nl.pinterest.com/pin/347973508687634096/
The original Prusa has been copied so many times that it will be quite a quest to find this (brand).