Avisos
Vaciar todo
PrusaSlicer: Printbed model
I successfully installed PrusaSlicer . The prinbed shown is an ordinary grid. No print bed model.
Where can I get a model for MK3S and how is it configured in PrusaSlicer?
Any hint? Thanks!
Respondido : 25/05/2019 3:14 pm
RE: PrusaSlicer: Printbed model
During the installation you should have configured PrusaSlicer for your printer.
But if for some reason you skipped this you can do this again under the Configuration / Configuration Wizard menu.
Bear MK3 with Bondtech extruder
Respondido : 25/05/2019 3:23 pm
Topic starter
answered:
RE: PrusaSlicer: Printbed model
thanks, that worked. I imported the old Slic3r data but missed the configuration somehow. 👍
Respondido : 25/05/2019 3:42 pm