Avisos
Vaciar todo
Prusa i3 MK3s & Printing Prusa PETG
Hello,
I recently switched from PLA to PETG and I was noticing that circular holes, specifically, have a slight angle to them. Also edges have some roughness to them and aren't completely smooth. Does anyone have suggestions?
Respondido : 25/11/2020 5:27 pm
RE: Prusa i3 MK3s & Printing Prusa PETG
Are you sure you did not widen the part?
--------------------
Chuck H
3D Printer Review Blog
Respondido : 25/11/2020 6:55 pm
Topic starter
answered:
RE: Prusa i3 MK3s & Printing Prusa PETG
@cwbullet
No I didn't
Respondido : 25/11/2020 6:57 pm