Notifiche
Cancella tutti

Prusa i3 MK3s & Printing Prusa PETG  

  RSS
pmishkin
(@pmishkin)
New Member
Prusa i3 MK3s & Printing Prusa PETG

Hello,

I recently switched from PLA to PETG and I was noticing that circular holes, specifically, have a slight angle to them. Also edges have some roughness to them and aren't completely smooth. Does anyone have suggestions?

Postato : 25/11/2020 5:27 pm
cwbullet
(@cwbullet)
Utenti
RE: Prusa i3 MK3s & Printing Prusa PETG

Are you sure you did not widen the part?

--------------------
Chuck H
3D Printer Review Blog

Postato : 25/11/2020 6:55 pm
pmishkin
(@pmishkin)
New Member
Topic starter answered:
RE: Prusa i3 MK3s & Printing Prusa PETG

@cwbullet

No I didn't

Postato : 25/11/2020 6:57 pm
Condividi: