Prusa I3 / MK3 with MMU2 kit
Good day to all!
We recently received our new Prusa printer. All setup and configured from Prusa. When we received it we immediately added the multi material kit. When we started the printer for the first time we flashed both chips on the printer as instructed in the information supplied online. That all went smooth.
However from the first time we turned the machine on there is only the all I see on the LCD is 'Original Prusa I3 / Prusa Research ...'
Also on the multi material feeder I see one light lit up.
The printer was assemble (minus the MMU2 kit) when it arrived and the test print looked great. I've attach a couple images to show what I'm getting. Anyone have any ideas where I should start?
RE: Prusa I3 / MK3 with MMU2 kit
Ok I'm passed the problem with the LCD. Apparently when the control board was flashed the first time the wrong .hex file was used. The file we used was prusa3d_fw_3_9_1_MK3S. I went to the drivers page and looked deeper and found prusa3d_fw_3_9_1_MK3 (which is the exact one we have)
I downloaded and installed that and it resolved all those problems and it did the self calibration test.
Now I'm having a different problem but I'll start a new thread for that.