Avisos
Vaciar todo
Prusa Control stops at 21%
Hello,
PrusaControl stops always at 21% while generating gcode. I have updated to latest version, no change. The same PrusaControl software on my other PC is working well, so it is an issue with my PC I know. What should I check on this computer? ❓
Respondido : 15/05/2018 8:46 pm
Re: Prusa Control stops at 21%
Mine did the same with some STL files. Think it was just down to processing the information but not sure. I have changed to Slic3r PE version now and not had the same problem
Respondido : 15/05/2018 10:29 pm