Notifications
Clear all

Prusa Calibration fail  

  RSS
Kopplog
(@kopplog)
Estimable Member
Prusa Calibration fail

Hello,

I already am pretty annoyed, the manual explicitly said DON'T GREASE THE MISUMI BEARINGS... well, so I had to break my whole newly build MK3S apart, clean the bearings, apply grease, build the printer up again, hours of work.

But:

Now, as I startet to run the calibration (1st after telling me to apply paper sheet) it nailed the nozzle so hard into the heatbed, the paper punctuated roughly!!!

Thanks for your help, in fear, c

Napsal : 30/06/2021 12:27 pm
muddymaker
(@muddymaker)
Estimable Member
RE: Prusa Calibration fail

Why did you that?

Napsal : 30/06/2021 12:30 pm
Kopplog
(@kopplog)
Estimable Member
Topic starter answered:
RE: Prusa Calibration fail

Okay, it sounded and looked like the machine is destroying itself....

Now I got: CALIBRATION FAILD. BED CALIB POINT NOT FOUND?!

 

WTF.... 

Napsal : 30/06/2021 1:27 pm
Lichtjaeger
(@lichtjaeger)
Noble Member
RE: Prusa Calibration fail

Check your PINDA. Connection and positioning.

Napsal : 30/06/2021 1:41 pm
Share: