Notifications
Clear all

Printing Issues  

  RSS
will.bowes1
(@will-bowes1)
New Member
Printing Issues


I have recently started printing and a lot of my prints come out well but for some reason bigger ones come out like this and I’m not sure why. I am using the prusa slicer and set it to the printer that I own. The only thing I can think of is that because I have it on upstairs, I put it on top of a box to stop the vibrations coming through the floor, and this could potentially be the issue, however I have put it on the box lots of times and had no other issues. The Z axis is correct on it but can’t think what else it may be. Would anyone be able to help please?

Posted : 05/12/2022 7:51 pm
Neophyl
(@neophyl)
Famed Member
RE: Printing Issues

That looks like a filament feed issue.  Its skipping extrusion which leads to the gaps.  You will have to debug just what is causing that though as there isn't a single cause.

Posted : 05/12/2022 8:30 pm
will.bowes1
(@will-bowes1)
New Member
Topic starter answered:
RE: Printing Issues

Hi,

i will have a look and give it a try. Thank you so much for that

Posted : 05/12/2022 8:34 pm
Share: