Avisos
Vaciar todo
Possible underextrusion
Hello, I have been printing with different PLA rolls with good result, today I tried Glitter PLA and the results weren't great.
The layers aren't sticking together properly, so I think its an underextrusion problem. What can I change to solve this?
Thanks
Respondido : 16/05/2020 1:51 pm
RE: Possible underextrusion
Are you sure your glitter particles aren't too big and can cause partial clogs in the nozzle?
Respondido : 17/05/2020 2:30 pm
Topic starter
answered:
RE: Possible underextrusion
@bart-l2
I have checked with the manufacturer and they say that there shouldn't be any problems using that nozzle size. They just said to use a higher printing temperature.
Respondido : 19/05/2020 8:22 am