Notifications
Clear all

Possible underextrusion  

  RSS
Emily
(@emily)
Active Member
Possible underextrusion

Hello, I have been printing with different PLA rolls with good result, today I tried Glitter PLA and the results weren't great.

The layers aren't sticking together properly, so I think its an underextrusion problem. What can I change to solve this?

Thanks

Posted : 16/05/2020 1:51 pm
educa
(@educa)
Active Member
RE: Possible underextrusion

Are you sure your glitter particles aren't too big and can cause partial clogs in the nozzle? 

Posted : 17/05/2020 2:30 pm
Emily
(@emily)
Active Member
Topic starter answered:
RE: Possible underextrusion

@bart-l2

I have checked with the manufacturer and they say that there shouldn't be any problems using that nozzle size. They just said to use a higher printing temperature.

 

Posted : 19/05/2020 8:22 am
Share: