Notifications
Clear all
Phaetus Dragonfly (BMO) - my experience
Before I start...
No, I haven't run that heatsink. I return it, before risking not being able to return it as unused/brand new.
The reasons:
- Bad (not complete) installation guides to be found worldwide and no videos to be found.
- The BMO version with its collet-clip it didn't fit into the Mk3(all) flange... and I again, I couldn't find any information on that issue...
- I wasn't able to find out which TPFE-tube and in which dimension should fit through the collet. Also, no information whatsoever on that issue.
- It came without any TPFE-tube, although there were (lots of) spare parts/ wrenches included (which is good).
That's all... happy to read your thoughts on this...
Posted : 25/11/2021 3:58 pm
RE: Phaetus Dragonfly (BMO) - my experience
When you say TPFE are you meaning PTFE?
Before I start...
No, I haven't run that heatsink. I return it, before risking not being able to return it as unused/brand new.
The reasons:
- Bad (not complete) installation guides to be found worldwide and no videos to be found.
- The BMO version with its collet-clip it didn't fit into the Mk3(all) flange... and I again, I couldn't find any information on that issue...
- I wasn't able to find out which TPFE-tube and in which dimension should fit through the collet. Also, no information whatsoever on that issue.
- It came without any TPFE-tube, although there were (lots of) spare parts/ wrenches included (which is good).
That's all... happy to read your thoughts on this...
--------------------
Chuck H
3D Printer Review Blog
Posted : 09/12/2021 11:17 am
Topic starter
answered:
RE: Phaetus Dragonfly (BMO) - my experience
PTFE
Posted : 09/12/2021 2:40 pm