Notifiche
Cancella tutti
Petg help
Evidently I’m not mean’t to print petg… I this was printed at default settings, I dried the filament at 65c for about 8 hours. It has fairly prominent layer lines and bad overhangs (what you can tell from a calibration cube at least) I might just be expecting more than the technology can give.
Postato : 18/01/2023 2:57 am
Topic starter
answered:
RE: Petg help
Here is a picture showing the layer lines a little better.
Postato : 18/01/2023 3:37 am
RE:
You will get more help if you post in the section relevant to your printer, also, if you provide more details, e.g. printer model, any mods, filament make, slicer settings such as temp settings. etc.
Postato : 18/01/2023 6:10 pm
RE: Petg help
Did you try the suggestions made in the first thread you started a few days ago?
Postato : 18/01/2023 10:09 pm