No way to resume print after a pause?
Sliced with 2.9.0. Firmware 3.14.0-8066. Print paused as it should have. I needed to add custom made supports, but there's nothing on the screen to resume. Prusa connect shows it as "printing". Tried to pause it on connect, but it did nothing. Bed is still heated, but nozzle has cooled. Have 2 pauses which show M601 in the slice(used add pause). Any ideas how to continue this?
RE:
I've looked through the Gcode on the left and don't see M601. Not sure how it paused then. Tried slicing with M600 filament swap and/or adding custom gcode and neither show up. Am I missing something?
RE: No way to resume print after a pause?
Looking closer at gcode, it looks like it adds those codes before it starts the layer. Still no explanation as to why I wasn't able to resume. 3 hours and alot of filament wasted.....