Notifications
Clear all
Nextruder issues on my XL
5T XL
One extruder constantly clicks while it tries to load filament until the whole machine crashes and gives a notification about thermistor wiring (it gives the same message even if I change out the wiring)
Another extruder purges filament just fine, but as soon as I start a print, nothing comes out the nozzle and the wheel inside the nextruder stops moving to drive through the filament
Any suggestions on how to fix these?
Thanks
Opublikowany : 09/02/2026 8:18 am
RE: Nextruder issues on my XL
Hello.Let me guess: you have firmware 6.4.0 installed? If so, you can find help here.
https://forum.prusa3d.com/forum/postid/780819/
Bye
Opublikowany : 09/02/2026 12:08 pm