Migrate STLs from Thingiverse to Prusaprinters
We all know that Thingiverse has been getting worse and worse and it is only a matter of time before it gets shut down permanently after all the bugs it has.
RE: Migrate STLs from Thingiverse to Prusaprinters
We all know that Thingiverse has been getting worse and worse and it is only a matter of time before it gets shut down permanently after all the bugs it has.
It is growing increasingly unstable.
--------------------
Chuck H
3D Printer Review Blog
RE: Migrate STLs from Thingiverse to Prusaprinters
We all know that Thingiverse has been getting worse and worse and it is only a matter of time before it gets shut down permanently after all the bugs it has.
For this reason I left thingiverse.com a long time ago and now only post my project at grabcad.com and the prusaprints. I manually ported some projects to the prusaprints. This works the safest way, but requires some work.
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
RE: Migrate STLs from Thingiverse to Prusaprinters
@karl-herbert
Good to know. I have started doing the Same.
--------------------
Chuck H
3D Printer Review Blog
RE: Migrate STLs from Thingiverse to Prusaprinters
Perhaps I haven't been paying close enough attention, but in what way is Thingiverse "unstable"? I haven't experienced any issues.
Hear ye, Hear ye! Step right up folks and get your Government salvation here! Less than $.002 per word! Amazon.com/dp/B0B8XMMFP4