Is this a heatbed issue?
Mk3S+, Overture PETG
So, I have been printing several iterations of a MagSafe charger holder that is essentially a rectangular box with a circular hole to mount the charger puck. The part comes out OK but one corner is a little odd...see photo. And it is not just the first layers, but the finished top of the part also has a different look in this area. This repeats no matter quality or speed setting. Is this maybe a heatbed issue... or something else?
RE: Is this a heatbed issue?
PETG, large flat area.
Try printing on glass.
Your first layer 'Z' offset calibration is a fraction too low, too much squish.
Cheerio,
RE: Is this a heatbed issue?
Why is it messed up just in the corner, then? The mesh leveling should make it the same over the entire bed, correct?
Your first layer 'Z' offset calibration is a fraction too low, too much squish.
Cheerio,