How not to infill the thin section?

Dernier message

RSS

4XS

(@4xs)

Eminent Member

How not to infill the thin section?

How do I change this infill pattern to be aligned with perimeter, In this case it makes no sense to fill anything with zigzag, if only 2 trace wide.

Best Answer by Neophyl:

Change your topfill type to concentric

Publié : 19/07/2023 9:19 am

Neophyl

(@neophyl)

Illustrious Member

RE: How not to infill the thin section?

Change your topfill type to concentric

Publié : 19/07/2023 10:10 am

4XS

(@4xs)

Eminent Member

Topic starter answered:

RE: How not to infill the thin section?

Thanks this is very useful setting, concentric significantly improved printing time and stability of adhibition. I did fix this by increase the parameter thickness.

Publié : 20/07/2023 2:06 am

Mr Soul

(@mr-soul)

Membre

RE:

That is a very useful setting, concentric improved printing time and stability of the inhibition by a significant amount. Thank you very much. By increasing the parameter thickness, I was able to fix this issue.

Ce message a été modifié il y a 1 year par Mr Soul

Publié : 20/07/2023 11:36 am

Statistiques du forum

565 Forums

63.4 K Sujets

445.4 K Messages

19 En-ligne

68.5 K Membres

Le dernier des messages: How to set correct temps? Notre nouveau membre: Frickelfred Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé