Clear all

Has anyone tips on printing PET-G?  

New Member
Has anyone tips on printing PET-G?

I am printing PLA on my Prusa Mini+ for a long time and it works great. So I started to give PET-G a try, but I constantly get bad results and do not know what I need to change to fix it (see picture below). Does anyone have some advice for me?


This topic was modified 9 months ago 3 times by Anthony_v_W
Posted : 07/03/2023 8:30 pm
Veteran Member Moderator
RE: Has anyone tips on printing PET-G?

Hi Anthony, 

I had a look at your post and there is no picture within the post, 

Could you please save your prusa slicer project as a .3mf file, then zip compress the file, and attach the zipped file to your next post, 

regards joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Posted : 08/03/2023 10:07 am